Female Adapters

 With a 3/8-24 female on the one side to connect to any male 3/8-24 fitting there are plenty of uses and the other end we have a standard male BC fitting you can connect with

With some many divers now building their diving sets with more configurations that ever before we keep adding new adapters to allow you for more ways to build your diving rig 

 With a 3/8-24 female on the one side to connect to any male 3/8-24 fitting there are plenty of uses and the other end we have a standard female BC fitting you can connect with

This adapter is go to allow your low pressure hoses to swivel or add a little bit of a standoff from your first stage

Allows your regulators to have less line twist or hard if they bind up this will help reduce this issue 

This swivels a full 360 degrees 

The 9/16-18 female end spins / turns on and the 3/8-24 male you can just screw on and tighten with a wrench

This is a one piece unit and the inside stem is held in place by a internal clip 

Here is our latest adapter using a 2 piece design Adapter!

You thread the male end on and tighten it down with a 4mm allen head wrench

The other end is the our 9/16-18 Female end which you can use a wrench to tighten down with 

Also is nitrox ready if you need it to be 

* Here is a 3 way low pressure block

* Has 3 female 3/8 threaded ends

* This is a small 3 way adapter block!

Overall Length: 1 1/2" inches

Thinkness: 9/16 

Our nestest adapter give you a a low pressure stand off of 7/8" inches long

We also use a viton o-ring so this is good for air or mix gasses

To screw down the 3/8 male end you will need a 4mm allen wrench which you go down the adapter and tight down! This allows this adapter to swivel 360 degrees

3/8-24 male end

3/8-24 female end

Rotates 360 degrees