Male End Adapters

This adapter is go to allow your low pressure hoses to swivel or add a little bit of a standoff from your first stage

Allows your regulators to have less line twist or hard if they bind up this will help reduce this issue 

This swivels a full 360 degrees 

Our nestest adapter give you a a low pressure stand off of 7/8" inches long

We also use a viton o-ring so this is good for air or mix gasses

To screw down the 3/8 male end you will need a 4mm allen wrench which you go down the adapter and tight down! This allows this adapter to swivel 360 degrees

3/8-24 male end

3/8-24 female end

Rotates 360 degrees 

Here is our latest adapter using a 2 piece design Adapter!

You thread the male end on and tighten it down with a 4mm allen head wrench

The other end is the our 9/16-18 Female end which you can use a wrench to tighten down with 

Also is nitrox ready if you need it to be 

Another new adapter that has a 3/8-24 male to 3/8-24 male end on each side

Uses viton o-rings 

You can use this adapter to connect your computer depending on your design plus you want to your first stage plus many other uses

On one end you have a 7/16-20 end we had a small high pressure hole made so you do not need a spool to use with this fitting and the other end is a 3/8-24 male threaded fitting!! 

This adapter uses a buna o-ring but you can always switch after using it for a while with a viton if you need too 

Here is a popular size adapter!

Has a male 9/16-18 threaded end on one side and the other has a 3/8-24 male threaded end